Cyclo Drive Gear Motor




1. Multi-point meshing for high load capacity and strong impact/overload resistance
Multiple cycloidal gear sets mesh simultaneously during operation, distributing the load. The unit can withstand short-term impact loads of 3–5 times its rated torque without the risk of tooth breakage, making it well-suited for applications prone to material jams or significant shocks during start-stop cycles.
2. Wide single-stage gear ratio range; ultra-low output speeds achievable via two-stage configuration
Single-stage reduction ratios range from 9:1 to 87:1, while two-stage combinations can reach 121:1 to 5133:1. This allows for high reduction ratios without the need for complex multi-stage gear trains, resulting in a compact design with coaxial input and output shafts that saves installation space.
3. Rolling contact with minimal friction; stable, high-efficiency long-term operation
The cycloidal gear and the pin gear engage through rolling contact rather than the sliding friction found in worm gear drives. This ensures higher transmission efficiency-exceeding 90% for single-stage units-leading to lower energy consumption during prolonged continuous operation and better thermal control.

|
Model |
Cyclo Gear Motor |
|
Type |
B/X Cycloidal Pin-wheel |
|
Power |
0.18-75 kW |
|
Rated speed |
1390rpm |
|
Ratio |
7:1~658503:1 |
|
Output speed |
0.18-206.4 rpm |
|
Output torque |
up to 29400 N.m |
|
Motor voltage |
380V. 440V. |
|
Motor frequency |
50HZ 60HZ |
|
Motor insulation |
F, H |


























FAQ
Q: Can a cycloidal gear motor be installed and operated in a vertical, upward-facing orientation?
A: You may select a vertical-type (BLD series) model; however, it is essential to verify the sealing configuration. The lubrication system for this type differs from that of a horizontal model. Standard horizontal-type units should not be installed in an inverted or vertical-up position, as this is highly likely to result in oil leakage.
Q: Does operating a cycloidal reducer in reverse have any impact?
A: The structural design supports bidirectional operation, with consistent performance in both forward and reverse directions. No modifications to internal components are required; the direction of rotation can be changed simply by swapping the motor's phase sequence.
Q: What are the most common causes of oil leakage in cycloidal gear motors?
A: Overfilling the oil, aging or failure of oil seals, a clogged breather plug, incorrect model selection for vertical mounting, or excessive oil temperature leading to increased internal pressure.
|
|
|
|||
|
|
||||
Hot Tags: cyclo drive gear motor, China cyclo drive gear motor manufacturers, suppliers, factory
Previous
NMRV Worm Gear ReducerYou Might Also Like
Send Inquiry


































